Product information
Lock’n’Level is the all new approach to the old problem facing all caravan owners.
How can I get the caravan perfectly level and at the same time fit the wheel lock(s)?
Lock’n’Level will provide you with the solution to both problems at the same time…..and what’s more, achieve it with very little effort. The only additional equipment required is a standard tyre pump. You can forget all the planks, ramps, bottle jacks, wind-ups, hydraulic jacks and scissor jacks etc. Your Lock’n’Level renders them all redundant.
With a little practice you will be able to raise your single or twin axle caravan up to 6″ high, level it and fit both locks on a twin axle caravan in around 5 minutes. On a single axle it will take a lot less.
With the installation of motor movers, jacking a caravan or using a levelling ramp can be a major problem, not however for a Lock’n’Level! Unlike a lot of other levelling systems, the Lock’n’Level is totally unaffected by the installation of motor movers.
The fitting of motor movers on a twin axle caravan often necessitates the removal of the jacking points.
With Lock’n’Level you can even change any wheel on a twin axle. In the event of a puncture or to change a wheel you can use your Lock’n’Level as a jack.
A bonus! Because the ‘footprint’ of the Lock’n’Level is a lot larger than that of the tyre that it supports, it is much less likely to sink on soft ground.
The only additional equipment you will need is a 12volt tyre pump and your own choice of wheel locks. The Lock’n’Level works at such low pressures (up to 30 psi) that any pump good enough to inflate your tyres will be fine.